Details
Latex free. Contouring nose bridge. Non-sterile. This respirator is approved for the following configurations: TC - 84A-9272. Protection (N95 - Particulate Filter (95% filter efficiency level) effective against particulate aerosols free of oil, time use restrictions apply). Respirator: A105, X. Cautions and Limitations (Cautions and Limitation: A - Not for use in atmospheres containing less than 19.5% oxygen. B - Not for use in atmospheres immediately dangerous to life or health. C - Do not exceed maximum use concentrations established by regulatory standards. J - Failure to properly use and maintain this product could result in injury or death. M - All approved respirators shall be selected, fitted, used and maintained in accordance with MSHA. OSHA and other applicable regulations. N - Never substitute, modify, add or omit parts. Use only exact replacement parts in the configuration as specified by the manufacturer. O - Refer to user's instructions, and/or maintenance manuals for information on use and maintenance of these respirators. P - NIOSH does not evaluate respirators for use as surgical masks): ABCJMNOP. Made for non-woven, melt blown polypropylene. Be bright. Please recycle.
• Latex Free/No Natural Rubber Latex
Directions
Donning Instructions: Must be followed each time respirator is worn. 1. Cup the respirator in your hand, with the nose piece at your fingertips, allowing the headbands to hang freely below your hand. 2. Position the respirator under your chin with the nose piece up. Pill the top strap over your hand resting it high at the top of your head. Pull the bottom strap over your head and position it around the neck below the ears. Make certain hair, facial hair, jewelry and clothing are not between your face and the respirator as they will interfere with fit. 3. Place your fingertips from both hands at the top of the metal nose piece. Using two hands, mold the nose area to the shape of your nose by pushing inward while moving your fingertips down both sides of the nose piece. Pinching the nose piece using one hand may result in improper fit and less effective respirator performance. (Use two hands.) 4. Perform a User Seal Check. To check the respirator-to-face seal, place both hands completely over the respirator and exhale. Be careful not to disturb the position of the respirator. If air leaks around nose, readjust the nose piece as described in step 3. If air leaks around the respirator edges, adjust position of straps and make certain respirator edges fit snugly against the face. If you cannot achieve proper seal, do not enter any contaminated areas, See your supervisor. Mask should be discarded after each use.
