Motor Oil FUEL Fluid Extractor Electric Siphon Transfer Change Pump 12V

Note: This pump cannot pump gasoline and diesel, only non-corrosive liquid

Product Description:

100% brand new and high quality

Material: Metal + Plastic

Color: Black

Rated Voltage: DC 12V

Rated Power: 60W

Maximum Flow: 5L/min

Maximum Pressure: 0.8MPA

Pump Diameter: Approx. 5 cm / 1.97"

Length: Approx. 16cm / 6.3"

Cable Length: Approx. 60cm / 23.62

Clips Length: Approx. 8cm / 3.15"

Outlet PVC pipe Length:150cm

Nylon pipe Length:100cm

Quantity: 1 pc

Features:

How to use: Start to run the car engine for a while, when oil temperature turns to be about 50 degrees, start pumping oil

Connect the pump to the power, run it for a while, and observe whether the inlet and outlet is normal

Open the filler cap,get dipstick out, force the tube into the bottom of the joint, until the tube does not move

Then put the inlet pipe from the oil dipstick into in end (the tube into the bottom of the tank, the bottom concave place, in order to pump the oil completely)

As no oil or pumping up very slowly or intermittently, it is generally caused by loose pipes and fittings. You have to install the pipes and fittings again.)

After oil pumping, remove the tube, and then run the pump for a while, pump the remaining oil inside the pumping clean, or pump water for a while until the pump head gets clean

If you have not used it for a long time, it may have no suction, then just pour the water in the pump, and run the pump for a few minutes until the air is all out